Greenhouse Supply

Vent Motors

Several vent motor-gear boxes are available for venting, shading and side vents for glass and poly houses. Motors are available for 120 volts, 220 volts, 208 volt 3 phase and 575 volts 3 phase.

Control Panels

The vent control Panels are available to control two vent motors per panel and can accommodate single phase or three phase motors. The control panels are also available to control one motor per panel. Each panel is equipped with 24 volt relays to control the high voltage interlocked contractors.

Temperature & Humidity Sensors

Aspirated temperature and humidity sensors and temperature only sensors are available with weather proof connectors. Solid state temperature and humidity sensors are high accuracy and maintenance free.

E.C. Meter

The digital Conductivity (EC) meter-controller provides programmable relays to pulse electronic and pneumatic injectors proportionally according to EC set point. There are optional relays to allow you to program Hi-Low levels for alarms or proportional control relay outputs. They also have built in transistor output for connecting to the Fertigation Manager computer program. The meters are easily programmable through front panel keypad.

Water Meter

These digital water meter-controller provide programmable relays to pulse electronic and pneumatic fertilizer injectors proportionally to water flow. There are 2 optional relays to allow you to program Hi-Low level flow alarms and on-off control or proportional control outputs. They also have built in transistor output for connecting to the Fertigation Manager program. The meters are easily programmable through front panel keypad.

pH meter

The digital pH meter-controller can be programmed for pH, ORP, Dissolved Oxygen, or Moisture meter. There are optional relays to allow you to program Hi-Low levels for alarms or for proportional control. They also have built in transistor output for connecting to the Fertigation Manager computer program. The meters are easily programmable through front panel keypad.

Co2 Meter

There are several Co2 meter-controller available for controlling the Co2 levels in the greenhouse. The stand alone meter can be installed directly in the greenhouse to control Co2 gas burners or liquid Co2 valves. A second meter is available for remote sensing of Co2 in different greenhouse compartments. Both meters have analogue outputs to connect to the Co2 program in the Climate Manager computer. The hot water temperature sensor is a stainless steel probe with 3/4 inch NPT thread with a weather proof cap. Terminals are provided on top of the sensor to connect wiring to the Climate Manager control panel.

Level, Volume, Pressure and Temperture Meters

These digital  meters provides programmable relays to control equipment as required. They can easily control pumps, injectors, alarms, and other equipment. The digital display readout always shows you what is going on in the processes. The built in relays allow you to program Hi-Low alarms or control equippment. They all have 4~20 mA outputs for connecting to the Fertigation Manager program or any PLC. The meters are easily programmable through front panel keypad.